|Type of Product:||Heater assembly|
|Power:|| Volts: 230 |
Material spec: Incoloy |
Required flow rate: Set by pressure switch
Flow detection: No pressure switch supplied with the heater
Hot Tubs: Vita Spas |
Part Codes: C2300-0010ET
|Connections & Fixings:||Usually held in with a metal fixing studs at the top of the heater either side of the main heat terminals. Hi-limit sensor pouch on the topside. 2 inches white plastic female sockets to connect to plumbing|
|Dimensions:|| Length: ca. 36 mm |
Diameter: 50.8 mm
Between terminals: 31.75 mm
Overall length complete:
Can be used to replace HT-TH21U (C2300-1008ET)
You may find cheaper versions of this heater on the internet but they are most likely cheap copies. If it is not an official Thermcore, Aquatemp or Balboa product with genuine labelling do not buy it.
If your heater looks the same as this one it most probably is but contact us if you need further help.